Forum Replies Created
-
Posts
-
Hi Anabel,
How do you connect the device to your PC? Are you using the EByte board or a custom circuit?
Bye RenzoHi William,
I think there is a wiring issue or device problem; I think you must return to a breadboard and arrive at a working solution, then start to check all variations from this version.
Bye RenzoHi Erjon,
Sending emails requires a significant amount of memory at the exact moment the email is sent, so having only 20% of memory free might not be sufficient.
Bye Renzo
Hi Erjon,
w5500 not support TLS, so pay attention if you use It.If It doesn’t work after add more elements probably it’s a memory problem, try to disable attachments.
Bye RenzoHi William,
check the connection with a simple sender example so we can exclude some electronic issue.
Bye RenzoHi William,
to manage the WOR, you must do some additional things.
To preserve Sleep mode, you must hold down the M0 M1 pin and enable the ext GPIO wake-up.
You can find what you need in this article.Ebyte LoRa E32 device for Arduino, esp32 or esp8266: WOR (wake on radio) and new ESP32 shield – 8
Bye Renzo
Hi g,
remember that the power supply and antenna are crucial for the range of transmission; put also a good capacitor on the battery to supply sufficient peak current.
Bye RenzoHi all,
@Nunu00 seems to fix the problem here.BeePrint partially works with Ghost 5 and Marlin
Ask to him for more information, I don’t have Marlin.
Bye RenzoHi, the
stream.readBytesmust return the number of bytes read, as the documentation specifies, so I think it’s an ESP core temporary bug.
But I check better next.
Thanks for your feedback, RMMmmm… It’s strange that it doesn’t start, but with the last Marlin version, can you confirm that it works correctly?
Thanks RenzoHi Nunu,
first of all, try to format the SD card and use only the web interface to manage It as a test.
Bye Renzo
