[John]

Thank you very much, I do not find any gerber files in the master.

[John]

If I may change pcb layout where can I download the gerber files

[John]

thank you Renzo. All I need is 1 SSR to disconnect 100 to 200Volt DC, the relay will be a problem

can I modify your pcb to incorporate a SSR

[John]

thank you for your assistance. it is much appreciated

[John]

Thank you Renzo

I take note of the RTC version, just a quick question, will the pump auto start on low level and auto switch off on High level. My solar pump is located in the field approx 8 km from the house, the reservoir (5000 Liter) tank is 1km from pump, hence the request to auto start and stop. I cannot visit the pump on a daily basis and there is not internet or cell reception.

I thank you for your kind assistance

[John]

Good day Renzo

Do you have an update on the remote water level controller with auto start and stop. or how I can go about implementing it.

Thank you

[John]

Thank you Renzo
I am no software engineer, so this article is of great interest for me. I will wait to see your new project regarding auto stop auto start.

Many thanks

[Author]

Posts