Forum Replies Created
-
AuthorPosts
-
Hi xwingmll,
hehehehe.. sometimes the solution is to power off and power on.
Thanks, sorry for the issue I insert, but It’s a work in progress.
Please keep in touch if you find some other problem.
Bye RenzoSorry,
I fixed the regular expression, and I re-tested the library with an esp32 devkit v1 and It’s works correctly, I can reproduce your error by putting an AUX pin or M0 M1 pin wrong
Check the wiring or power supply.
Bye RenzoHi xwingmll,
when the device return data size does not match It’s a high probability that you wrong set M0 and M1 pins, or power supply issues.
Bye RenzoAzz, no sorry, I check a wrong project 😛
Bye RenzoHi mr.big,
thanks for your help, but I think you get an older version of i18n, please use this to add your language.
Thanks again RenzoHi Mike,
Probably pcf8474 maintains the state with the continuous current.
But my library restarted the pcf in Setup and I think you lost all.
Bye RenzoHi John,
It’s possible that I had continued the development of the library with an esp32, and so when the library grows, the memory of esp8266 It’s no more sufficient.
But I’m going to test and check these days, and I’ll give you more information.
Bye RenzoHi,
about this issue here you can find a possible solution
https://github.com/xreef/EByte_LoRa_E220_Series_Library/pull/11
It’s seems that there is an issue with software serial, but it’s very strange.
Even if the message say that the module working.
Bye RenzoHi Misio,
yes, I think It’s time for an upgraded version of It.
But I’m very very busy, I’d like to do some porting to micropython of my library and so on.
I need help 😛
Bye RenzoHi Giuseppe,
Data size not matching can be caused by wrong M0 M1 wiring or low power supply.
Bye RenzoHi Mayksuel,
the only thing you can put wrong It’s if you do a wrong configure of M0 and M1.
Bye RenzoHi,
I re-do all the specified test, and the library work correctly, the problem is born when you don’t set RSSI enabled on all devices, but only in one.
Bye RenzoHi Mark,
refer to the article, the documentation that is maintained is that.
PCF8575 i2c 16 bit digital I/O expanderThe pcf8575 doesn’t have sufficient power to light 5mm led, use It to put GND to the Catode.
Bye Renzo10 April 2023 at 08:43 in reply to: SMTP error: We do not authorize the use of this system to transport unsolicited change number response #25279Hi Sebastian,
to manage additional await, you can put 1 to this variable.Bye Renzo
8 April 2023 at 10:05 in reply to: SMTP error: We do not authorize the use of this system to transport unsolicited change number response #25265Hi Sebastian,
to enable DEBUG uncomment this line.An additional test is to enable automatic response by setting the value to ‘a’ at this line.
Bye Renzo
-
AuthorPosts