Electronic, 3D printing and embedded programming
Library to use i2c pcf8575 IC with arduino and esp8266.
This IC can control (until 16) digital devices like button or led with 2 only pins.
Can read and write digital value with only 2 wire (perfect for ESP-01).
I try to simplify the use of this IC, with a minimal set of operation.
Wherever I go, peoples asked me why I chose DHT12, and why I spent time to write a library for this small sensor, in this articles I’ll try to give an answer (competitor bmp280, DHT11, DHT22, Dallas and thermistor).
Finally the comparison.
Wherever I go, peoples asked me why I chose DHT12, and why I spent time to write a library for this small sensor, in this articles I’ll try to give an answer (competitor bmp280, DHT11, DHT22, Dallas and thermistor).
Today the code to get sensors fully working.
I’m going to create the famous Ciclop 3D Scanner, but my first problem is how to get round plexiglass base, but the costs is too expensive. So I decided to design a printable one.
Wherever I go, peoples asked me why I chose DHT12, and why I spent time to write a library for this small sensor, in this articles I’ll try to give an answer, and introduce the competitor bmp280, DHT11, DHT22, Dallas and thermistor.
Today the specification of the sensors I use.
