E22 UART fixed point transmission

Tagged: lora, Question

This topic has 2 replies, 1 voice, and was last updated 2 years, 9 months ago by Ben Wybourne.

Viewing 2 reply threads

Author

Posts
- 25 February 2022 at 05:40 #18914
  Ben Wybourne
  Hello
  
  I am using both E22-900T22DC and E22-900T30DC. For testing I am using direct communication from a PC terminal, rather than arduino.
  
  I can make everything work fine, except “Fixed Point Transmission”. I see the E22 library supports this and I have carefully examined what the library is doing.
  
  When bit 6 of register 0x6 is set high, I do not receive data. I have scoped the UART data going to the module, and it includes the correct address and channel data in the first three bytes, as expected. The receiving module is also configured exactly as in the E22 library example.
  
  When the Fixed Point Transmission bit is low, addressing works as expected (data sent when RX and TX modules have same address and channel, and also FFFF broadcast and FFFF monitor works for channels).
  Otherwise I am wondering if the firmware in my modules has a bug.
  
  Thanks for any comments!
  
  Ben
- 25 February 2022 at 07:46 #18915
  Renzo Mischianti
  Keymaster
  Hi Ben,
  you can check in this forum and in the GitHub issue that a lot of people use the Fixed Transmission with heterogeneous device.
  I think there is a problem in configuration or in the sender pachet.
  Bye Renzo
- 21 March 2022 at 04:14 #19641
  Ben Wybourne
  Figured out the problem! I misinterpreted the datasheet. I assumed the third byte sent needed to match the NetID – but it needs to match the RF Channel (register 0x05).
  
  Now fixed transmission works as expected, my mistake.
Author

Posts