- This topic has 3 replies, 2 voices, and was last updated 2 years, 7 months ago by
.
-
Posts
-
-
Hi Renzo, your LIB works perfect, many thanks to you!
I have a question that may not be directly related to the library, but I can’t find a solution for it.
If I send more than 4 messages (regardless of length) in a row (transparentTransmission) then the transmission module goes down and you have to reboot it.
Is this perhaps a Lora rule? … if so, can this be switched off?
Thanks for your work, Georg -
-
Hi Renzo,
thank you very much for the quick reply.
here the code for Lora send. The amount of data is about 15 characters.// ************** LoRa-Send *****************
void LoraSend(int _counter, unsigned long _wert_millis) {String temp; // Sendedaten zusammenbauen
temp = “Nr: ” + String(_counter) + ” Millis: ” + String(_wert_millis);// Send message
//e220ttl.sendMessage(temp);
ResponseStatus rs = e220ttl.sendMessage(temp);
// Check If there is some problem of succesfully send
Serial.println(rs.getResponseDescription());
}
// ************** END LoRa-Send *****************At the sender I always get the answer “successful”, even when sending more than 4 telegrams.
the first 4 telegrams arrive also without problems at the receiver, then unfortunately nothing more comes.
After that, no reset of the send-ESP32 helps, but only removing the voltage of the send-Ebyte220 – only then another 4 telegrams come through again.
Many thanks in advance for your help,
Georg -
-
- You must be logged in to reply to this topic.
