E220-900T30D No Interrupt

Function switchOne not sending struct Message members to Sender:

`void switchOne(int data) {

if (data == 1) {
int data = 1;
Serial.println(“\nBattery Switch is ON”);
Serial.println(“ESP32 waking from Deep Sleep\n”);
}

if (data == 2) {
int data = 2;
Serial.println(“\nBattery power switched OFF”);
Serial.println(“ESP32 going to Deep Sleep\n”);
}

Serial.println(“Hi, I’m going to send message!”);

e220ttl.setMode(MODE_0_NORMAL);
delay(delayTime);

get_time();

Message message;

//initialize struct members
message.switchState = data;

//Initialize the dateTime
String dateTimeStr = get_time();
if (!dateTimeStr.isEmpty()) {
strncpy(message.dateTime, dateTimeStr.c_str(), MAX_dateTime_LENGTH – 1);
message.dateTime[MAX_dateTime_LENGTH – 1] = ‘\0’; // Ensure null-termination
}

Serial.print(“switchState: “); Serial.println(message.switchState);
Serial.print(“dateTime: “); Serial.println(message.dateTime);

// Send message
ResponseStatus rs = e220ttl.sendFixedMessage(0, DESTINATION_ADDL, CHANNEL, &message, sizeof(Message));
// Check If there is some problem of succesfully send
Serial.println(rs.getResponseDescription());
}

Additionally WOR message is transmitted successfully; Receiver does not respond. Checked pullup resistors; all 3.3V opposite of the 3.3V rail, referenced to ground.

M0 = 21, M1 = 19, TXD = 17, RXD = 16, AUX = 15 Vcc = 3.3V, and GND = Ground. Pin connections verifed by continuity tests. Modules programmed by Ebyte, RF software. Receiver ADDL 2, Channel 66, Tran Fixed, WOR period 2000ms, Power 30dbm. Sender same except ADDL 3.

7/6/2024 E220 Project code

Regards,
William

• This reply was modified 5 months, 1 week ago by William. Reason: Correcting text

Confused with simple Fixed Transmission, Sender example reults.

Modules configuration was done using Ebyte software application.

First, used the “Normal connections” to program E220 module, then used “Fully connected” to execute sketch. Sending of message from either Sender or Receiver only produces word “Success”; on module sending message. Message does not appear as the sent word “test”; does not appear on either serial monitor.

Both Sender and Receiver crash when trying to exeute sketch with “Normal connections”.

Please explain diffence between the pin connections listed as comments at top of sketch and the pins used in esp32 constructor.

Both Send and Receiver reported wrong configuration values from what was programmed with Ebyte programming software.

Best Regards,
William

• This reply was modified 5 months, 1 week ago by William. Reason: Clarifcation of early morning post

Have E220-Remote_Switch project working; posted to Espressif, ESP32.com, link to project code on Github and a Demo video of E220-Remote-Switch project.

E220-Remote-Switch Post link

Respectfully,
William

Have article ready; do you want it uploaded here or somewhere else?

William