Home › Forums › The projects hosted on the site › MKS WiFi firmware and BeePrint web interface › How do I modify the UI of the web?
- This topic has 5 replies, 3 voices, and was last updated 2 years, 4 months ago by
Renzo Mischianti.
-
AuthorPosts
-
-
25 April 2022 at 15:14 #20542
Hi Renzo Mischianti
I would like to modify it to suit laser engraving use. I am a novice and not very familiar with Arduino. Can I build it using VScode? Any advice and tutorials? Many thanks!I tried to compile using Arduino and got the following error.
The project is being compiled…(Annexes)
Attachments:
You must be logged in to view attached files. -
25 April 2022 at 21:44 #20546
Hi CLP58,
you can find all information on the site, you can start from this article and go on.MKS WIFI for Makerbase Robin: boards and how to wiring esp12 & NodeMCU – 1
Bye Renzo
-
26 April 2022 at 04:26 #20549
Thank you so much for your reply!
I have created the build folder, but I’m not sure what I should do next. After putting it into the MKS WiFi MISCHIANTI data, I failed to compile it. As prompted above. I’m not sure what I’m doing wrong.Upload to SPIFFS, does it have to be compiled as a bin file? -
26 April 2022 at 08:05 #20550
Hi CLP58,
don’t worry It’s all written in the guide.
Bye Renzo -
28 December 2022 at 20:23 #23755
Hello Renzo,
Hope you had a wonderful holiday.
Finished testing this with mainboard (Robin Nano v3.5) for the Fokoos Odin 5 F3 printer.
It was a success surviving numerous FW flashes from stock to marlin.This is wonderful work – thank you for sharing it.
I am curious about a few things:1) how many hours went into completing this task?
2) can additional features be added/coded for that are not included?
3) would you ever consider permitting people to see modules pre-flashed?
4) have you ever integrated this with marlin firmware directly?I was hoping to have documentation reviewed prior to opening it up to the community.
Found my way here from YouTube where Renzo told me to reach out here.Thank You,
RON -
28 December 2022 at 22:42 #23756
Hi Ron,
you can find all the information here.I spend a lot of time changing the firmware and creating a web interface.
I changed only the firmware of the MKS WiFi module without changing the printer firmware, so It can be used with many printer variants without creating problems.
You can find the source code of the esp8266 firmware and the repository with the complete project of the web interface at the end of every article.
Bye Renzo
-
-
AuthorPosts
- You must be logged in to reply to this topic.