- This topic has 9 replies, 3 voices, and was last updated 1 month, 2 weeks ago by
.
-
Posts
-
-
I’ve tested and now I know that current release (1.3) is completely compatible with Flying Bear Ghost 6.
Only problem what I seen is that after flashing new firmware my router refused to connect it. But after router reboot, connected good.
Installation process is the same as on Ghost 5. -
-
Hello, first at all thanks for great work.
I just installed Beeprint on my Flying Bear Ghost 6 and I’ve encountered a problem. After finishing printing, the printer reboots. This only happens when uploading files via wifi.
Also, it’s impossible to delete a file from the SD card via the web interface.
Are there any ways to fix these problems?-
-
Hello. Today I created two identical gcode files, one of which I saved and the other I sent via wifi. Then I compared them. The one that was sent via wifi contained the following codes at the end of the file:
M105 M997 M994 M992 M27 M105 M997 M994 M992 M27For some commands I couldn’t find a description in the marlin manual.
These commands force the printer to reboot. Is there anything I can do about these? -
Found similar thread on GitHub:
https://github.com/xreef/MKS_WIFI_upgrade_with_BeePrint_web_interface/issues/41
-
-
-
-
-
-
- You must be logged in to reply to this topic.
