Electronic, 3D printing and embedded programming
I finally buy another 3D printer, this time I choiche the FlyingBear Gost 5, and I made a case because I would like to print a more dangerous material like ABS, and to do that I create two different backs of the top cover, one standard and one with a fan for extracting harmful fumes. Fron cover/panel.
I finally buy another 3D printer, this time I choiche the FlyingBear Gost 5, and I made a case because I would like to print a more dangerous material like ABS, and to do that I create two different backs of the top cover, one standard and one with a fan for extracting harmful fumes. Top cover.
I’m going to use the esp32, and the first problem was how to put It on breadboard, so we are going to print an adapter, then I build a PCB to program.
ESP32, continue the little guide on how to use this low cost but powerful microcontroller with WIFI integrated.
Pinout, specification and IDE configuration to start use your esp32-wroom-32 esp32-s variant.
When I went to use esp12 and esp07, and the first problem was how to put it on the breadboard, luckily I found an adapter developed by tweeto, and that was what I needed, but I would like to make it easier to use, so I redesigned it smaller and added some labels to identify the pins, than I create a PCB to use It as programming board.
ESP8266, a little guide on how to use this low cost but powerful microcontroller with WIFI integrated.
Pinout, specifications and IDE configuration to start and programming your esp-12 and esp-07 variants.
I’d like to monitoring my ABB Aurora inverter. So with an WeMos D1 mini I create a centraline with web interface, notification and other.
Now a case where you can insert all the component to complete the work.
When I’m going to hang a picture the first problem is if I have a pins, this little tool help me to do a good job, but when I need they, never I can find they.
My solution is to reate a similar tool to print in 3d.
Summer work for my wife, a little lantern with led and removable battery
I’m going to create the famous Ciclop 3D Scanner, but my first problem is how to get round plexiglass base, but the costs is too expensive. So I decided to design a printable one.
