CNC Cyclone PCB Factory: control panel and bluetooth – Part 5
I’d like to renew my cnc for PCB so I decide to create new one from an existing project named Cyclone PCB Factory.
Control panel and bluetooth connection for wireless control.
Category: Arduino
CNC Cyclone PCB Factory: probe and relay – Part 4
I’d like to renew my cnc for PCB so I decide to create new one from an existing project named Cyclone PCB Factory.
Here we’re going to see how reduce noise on probe helper and add a relay to activate rotary tool.
CNC Cyclone PCB Factory: limit switch – Part 3
I’d like to renew my cnc for PCB so I decide to create new one from an existing project named Cyclone PCB Factory.
Here we’re going to see how reduce noise and wiring limit switch.
CNC Cyclone PCB Factory: Arduino CNC Shield, stepper and driver – Part 2
I’d like to renew my cnc for PCB so I decide to create new one from an existing project named Cyclone PCB Factory.
Here we are going to see CNC shield, Stepper driver and stepper motor
How to reuse 4 and 6 wires stepper motors for your projects
When you start to create a CNC or something similar you need a stepper motor, probably you can find they inside your trash.
It’s important to understand the stepper motor color code for 4 and 6 wire type.
CNC Cyclone PCB Factory: mechanics – Part 1
I’d like to renew my cnc for PCB so I decide to create new one from an existing project named Cyclone PCB Factory.
Introduction and mechanical part.
Arduino Remote/wireless Programming
You may need to program Arduino microcontroller (like) remotely to debug in the freezer.
Here is my solution to the problem.
ESP-01 modules programming board
ESP-01 is low cost esp8266 module, with built-in WIFI.
It was created as Arduino WIFI module, but It’s more powerful than an Arduino, than now if you need a little module to control a relay or some simple digital datalogger It’s the best solution.
Character LCD I2c Adapter
I’m going to explain a connection schema for a character display i2c adapter.
PCF8591 i2c Analog I/O Expander
Library to use i2c pcf8591 IC with arduino and esp8266.
This IC can control (until 4) analog input and/or 1 analog output like measure voltage, read thermistor value or fade a led.
Can read analog value and write analog value with only 2 wire (perfect for ESP-01).
I try to simplify the use of this IC, with a minimal set of operation.
